Dss-networks 5262-SC Manual de usuario descargar pdf (Pagina 31)

GigMAC-PMC and PCI

GigPMC Switch Board and Driver Users Manual

DSS NETWORKS, INC. Version: 2.6 Page: 31

TUNING THE INSTALLATION

Interrupt holdoff (programmed latency)

To increase (or decrease) the value of the programmed interrupt latency, insert the

module and set the "IntrHoldOff" parameter as follows:

insmod ./dpm.o IntrHoldOff=1 # value can be 0, 1, 2 or 3

Note: A value greater than 3 is not recommended.

Other driver parameters that can be set during driver load or in modules.conf:

MediaSpeed=10,100,1000 # Media Speed (default 1000)

SetAutoNeg=0,1 # Setting for auto negotiation (default 1=auto)

DuplexMode=0,1 # Setting for duplex (default 1=FULL)

IntrHoldOff=0,1,2 # interrupt holdoff value in 100 microsecond

units

ChipSelector=0,1 # default=1 (Intel), 0=National

NumBufDescs=<cnt> # default=256, 128, 256, 512, 1024

MaxBufferSize=<size> # default=2048, 2048, 4096, 8192

FrameGenSize=<size> # frame generator test size (64-9000 bytes)

See “Command Line Parameters” table below for additional information on driver

module insertion parameters.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 53 54

Sin comentarios

Dss-networks 5262-SC Manual de usuario Pagina 31